Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica descarregar pdf (Página 35)

642-531

C. IDS Device Manager

D. IDS Event Viewer

E. Session command

F. IDS Management Center

Answer: A, E

Explanation:

The Catalyst 6000 family switch can be accessed either through a console management session or through

telnet.

Reference:Cisco Secure Intrusion Detection System (Ciscopress) page 498

QUESTION 80

Which command would you will you advice the new Certkiller trainee technician to use inorder to view

the initial configuration parameters on the IDSM2?

A. show capture

B. setup

C. show running-config

D. session

Answer: B

IDS course 4.0 page 8-8 Initialize the IDSM2 this includes completing the basic configuration via the setup

command.

Note:

After you enter the setup command the default settings are displayed.

(Press spacebar to continue the setup).

Cisco Courseware 7-26

QUESTION 81

Enter the Cisco IDS 4210 Sensor command used to initialize the Sensor.

Answer: sys config-sensor

Reference: Cisco Intrusion Detection System - Cisco Secure Intrusion Detection Sensor Cabling and Setup

Quick Reference Guide

QUESTION 82

The new Certkiller trainee technician wants to know which of the following is one task that can be

performed while in the interface sensing configuration mode from the Sensor CLI.What would your

reply be?

A. add a sensing interface to the group

B. configure the interface's IP information0

C. disable the sensing interface

D. configure alarm setting

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 122 123

Sem comentários

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica Página 35