Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica descarregar pdf (Página 19)

642-531

Answer: B, D

Page 146 Cisco Press CCSP Chapter 6 Capturing Network Traffic

Step 1: Define a security ACL

Step 2: Commit the VACL to memory

Step 3: Map the VACL to VLANs

Step 4: Assign the capture port

Note:Does the 4000 switch really support VACLs?

QUESTION 45

The new Certkiller trainee technician wants to know what binds the input and output of a source RSPAN

session on a Catalyst 6500 switch running IOS.What would your reply be?

A. RSPAN vlan-id

B. interface number

C. SNMP ifIndex

D. single command implicitly maps inputs and outputs

E. session number

Answer: E

Cisco Courseware 5-20 (source)

Cisco Courseware 5-21 (destination)

QUESTION 46

Study the exhibit below carefully:

According to the exhibit all switches are connected through Fast Ethernet connections. Server Certkiller 5

and Sensor ID Certkiller 5 are in the same VLAN.

Which of the following commands represents a valid configuration step to permit Sensor IDS5 to monitor

traffic to Server Certkiller 5?

A. fasthub(config)# monitor session 1 source interface fastEthernet 0/5 tx

B. fasthub(config)# monitor session 1 source interface fastEthernet 0/5 rx

C. fasthub(config-if)# port monitor fastEthernet 0/5

D. fasthub>(enable) set span 0/5 0/24 both

E. No SPAN configuration is required since both devices are in the same VLAN

Answer: E

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 122 123

Sem comentários

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica Página 19