Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica descarregar pdf (Página 117)

642-531

specified in the global statement, that address is port translated. The PIX allows one port translation per

interface and that translation supports up to 65,535 active xlate objects to the single global address. The first

1023 are reserved.

Reference:Cisco Secure PIX Firewall (Ciscopress) page 91

Using nat, global, static, conduit, and access-list Commands and Port Redirection on PIX

QUESTION 262

With regards to the PIX Firewall, which two terms are correct from the below list?

A. All PIX Firewalls provide at least two interfaces, which by default, are called outside and inside.

B. All PIX Firewalls provide at least two interfaces, which by default, are called Eth1 and Eth2.

C. All PIX Firewalls provide at least two interfaces, which by default, are called Right and Left.

D. All PIX Firewalls provide at least two interfaces, which by default, are called Internet and External.

Answer: A

Explanation:

With a default configuration, Ethernet0 is named outside with a security level of 0 and Ethernet1 is named

inside and assigned a security level of 100.

Reference: Cisco Secure PIX Firewall (Ciscopress) page 56

QUESTION 263

What command could you use on your PIX Firewall to view the current names and security levels for each

interface?

A. Show ifconfig

B. Show nameif

C. Show all

D. Ifconfig /all

Answer: B

Explanation:

Use the show nameif command to determine which interface is being described in a message containing this

variable.

Reference:Cisco PIX Firewall Software Introduction

QUESTION 264

Which of the following commands let you view, change, enable, or disable the use of a service or protocol

through the PIX Firewall?

A. fixing protocol

B. set firewall

C. fixup protocol

D. change -all fix

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 123

Sem comentários

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica Página 117