Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica descarregar pdf (Página 27)

642-531

Sensor output exhibit: ***MISSING***

Note: Use the sensors command line interface to obtain information so that you can answer the question.

You are NOT expected to do any configuration.

Which of the following states would be displayed if the Sensor has established a connection to the router?

A. "State = Connected" in the Network Access Controller service's configuration mode.

B. "State = Connected" in the Network Access Controller's statistics.

C. "State = Active" in the Network Access Controller service's configuration mode.

D. "State = Active" in the Network Access Controller's statistics

Answer: D

No exact answer is provided in the course, but in the simulation look up the statistics, and you'll find the

State=Active

Command:

show statistics NetworkAccess

Cisco Courseware 9-40

QUESTION 64

Network topology exhibit/simulation

Sensor output exhibit: ***MISSING***

View the signature's settings.

The signature is not configured to perform blocking.

Note: Use the sensors command line interface to obtain information so that you can answer the question.

You are NOT expected to do any configuration.

Why isn't blocking working?

A. Blocking is not enabled on the Sensor.

B. The signature is not configured for blocking.

C. The router does not exist in the Sensor's known hosts table.

D. The signature is not firing.

Answer: B

QUESTION 65

Network topology exhibit/simulation

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 122 123

Sem comentários

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Ficha Técnica Página 27