Cisco 15310-MA Guia de Resolução de Problemas descarregar pdf (Página 318)

4-10

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 4 Error Messages

EID-2121 The ring cannot be upgraded.

{0}

CTC cannot upgrade the specified ring.

EID-2122 The ring speed for is inadequate for the upgrade procedure.

Only {0} (or higher) {1} can be upgraded to four-fiber.

You have selected an incorrect ring speed

for upgrade. Only rings within the specified

parameters can be upgraded to 4-fiber

BLSR.

EID-2123 Verify that the following nodes have at least two in-service

ports with the same speed as the two-fiber {0}. The ports

cannot serve as timing references, and they cannot have DCC

terminations or overhead circuits.

{1}

Nonupgradable nodes. Verify that the

specified nodes have at least two IS-NR

ports with the same speed as the 2-fiber

BLSR.

The specified ports cannot serve as a timing

reference, and they cannot have data

communications channel (DCC)

terminations or overhead circuits.

EID-2124 You cannot add this span because it is connected to a node that

already has the east and west ports defined.

Refer to the error message text.

EID-2125 You cannot add this span as it would cause a single card to host

both the east span and the west span. A card cannot protect

itself.

Refer to the error message text.

EID-2126 An error occurred while provisioning the OSPF area.

{0}

There is an Open Shortest Path First (OSPF)

area error.

EID-2127 You cannot add this span. It would cause the following

circuit(s) to occupy different {0} regions on different spans:

{1}

Either select a different span or delete the above circuit(s).

A circuit cannot occupy different STS

regions on different spans. You may add a

different span or delete the specified circuit.

EID-2128 The state is invalid. An internal error occurred while trying to

remove a span from a BLSR.

This alarm occurs in the network-level

BLSR creation dialog box.

EID-2129 You cannot use same slot for east and west protect ports. Refer to the error message text.

EID-2130 The ring ID value, {0}, is not valid. Please enter a valid number

between 0 and 9999.

Enter a ring ID value between 0 and 9999.

EID-2131 The reversion cannot be set to INCONSISTENT. You must select another reversion type.

EID-2135 The overhead circuit preferences could not be stored:

{0}

Input/Output error. Unable to store

overhead circuit preferences.

EID-2137 An error occurred during the circuit merge.

{0}

There was an error while merging the

circuits.

EID-2138 Not all destinations could be deleted.

Please try again.

Refer to the error message text.

EID-2139 An error occurred while updating the destinations. There was an error in updating the circuit

destinations.

Table 4-1 Error Messages (continued)

Error/Warning

ID Error/Warning Message Description

1 2 ... 313 314 315 316 317 318 319 320 321 322 323 ... 379 380

Comentários a estes Manuais

Sem comentários

Cisco 15310-MA Guia de Resolução de Problemas Página 318

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Cisco 15310-MA