Cisco 15310-MA Guia de Resolução de Problemas descarregar pdf (Página 346)

4-38

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 4 Error Messages

EID-5052 The operation is not valid for the connection type. You may have selected the incorrect switch.

EID-5053 The operation cannot be performed because the connection is

under test access.

Refer to the error message text.

EID-5054 The TL1 tunnel could not be opened. {0} Refer to the error message text.

EID-5055 Some patchcords were not deleted. Patchcords cannot be

deleted if they are incomplete or support any circuits, or if the

nodes supporting them are not connected.

Refer to the error message text.

EID-5056 This PPC cannot be deleted because one or more circuits are

provisioned over it.

Remove the circuits provisioned over the

provisionable patchcord before trying to

delete it.

EID-5057 The addition of the last node has not yet finished.

Please wait before trying to add a new node.

Refer to the error message text.

EID-5058 An OCHNC upgrade is applicable only to bidirectional circuits. Refer to the error message text.

EID-5059 The OCHNC upgrade failed.

One or more communication failures occurred during the

operation.

CTC encountered a complete failure while

upgrading optical channel network

connection.

EID-5060 The OCHNC upgrade partially failed.

One or more communication failures occurred during the

operation.

Create the OCHCC manually.

CTC encountered a partial failure while

upgrading an optical channel network

connection.

EID-5061 The overhead circuit source and destination must reside on the

same shelf.

Refer to the error message text.

EID-5062 A four-fiber {0} cannot be created using three cards. A four-fiber BLSR needs four cards.

WID-5063 The profile “{0}” includes a change to the OPEN-SLOT alarm

severity.

This change is disallowed for the ONS 15600. “{1}” will

continue to use the OPEN-SLOT severity of MN that is

included in the default configuration.

Other changes from the “{2}” profile were successfully applied

to {3}”.

Refer to the warning message text.

EID-5064 {0}

{1}

This indicates the status of path protection

switching.

WID-5065 If you apply routing constraints to more than {0} nodes,

performance might be affected and the operation might require

more time than expected.

Select Yes if you intend to proceed in spite of this risk, or No if

you prefer to review your selection.

Refer to the warning message text.

WID-5066 The routing constraints will be lost.

Are you sure you want to reset your changes?

Refer to the warning message text.

WID-5067 The routing constraints will be lost.

Are you sure you want to leave this panel?

Refer to the warning message text.

EID-5068 The routing constraints could not be applied. Refer to the error message text.

Table 4-1 Error Messages (continued)

Error/Warning

ID Error/Warning Message Description

1 2 ... 341 342 343 344 345 346 347 348 349 350 351 ... 379 380

Comentários a estes Manuais

Sem comentários

Cisco 15310-MA Guia de Resolução de Problemas Página 346

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Cisco 15310-MA