
4-20
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0
78-18394-01
Chapter 4 Error Messages
EID-3090 The operation cannot be performed because the {0} is
{1}LOCKED_ON/LOCKED_OUT.
You cannot perform operation.
EID-3091 The operation cannot be performed because the protect card is
active.
Refer to the error message text.
EID-3092 The requested action cannot be applied because the service
state is invalid.
Select another service state and proceed.
EID-3093 The operation cannot be performed because the duplex pair is
{0}locked.
Refer to the error message text.
EID-3094 The operation cannot be performed because no cross-connect
redundancy is available.
You cannot perform the requested operation
on the cross connect card without having a
backup cross connect card.
EID-3095 The deletion failed because the circuit is in use Refer to the error message text.
WID-3096 An internal communication error was encountered while
retrieving laser parameters.
This can happen when equipment is not present or when
equipment is resetting.
Check the equipment state and try to refresh the values again.
Refer to the warning message text.
EID-3097 The ring termination is in use. The ring termination you are trying to
access is in use. Try after sometime.
EID-3098 No ring terminations were selected. Select one of the ring terminations.
EID-3099 The entered key does not match the existing authentication key. Check the authentication key and reenter.
EID-3100 An error occurred during authentication. There was an error in authentication. Verify
that the key does not exceed the character
limit.
EID-3101 The DCC metric must be between 1 and 65535. The DCC metric should be in the range of 1
to 65535.
EID-3102 The DCC metric is invalid. There was an invalid DCC metric.
EID-3103 The IP address {0} is invalid}. The IP address is invalid.
EID-3104 The router priority must be between 0 and 255. The router priority should be in the range of
0 to 255.
EID-3105 The router priority is invalid. The router priority is invalid.
EID-3106 The hello interval must be between 1 and 65535. The hello interval should be in the range of
1 to 65535.
EID-3107 The hello interval is invalid. The hello interval is invalid.
EID-3109 The dead interval must be between 1 and 2147483647. The dead interval value must be between 1
and 2147483647.
EID-3110 The dead interval must be larger than the hello interval. Refer to the error message text.
EID-3111 The LAN transmit delay must be between 1 and 3600 seconds. The LAN transit delay should be in the
range of 1 to 3600 seconds.
EID-3112 The transmit delay is invalid. The transmit delay is invalid.
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message Description
Comentários a estes Manuais