Cisco 15310-MA Guia de Resolução de Problemas descarregar pdf (Página 362)

4-54

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 4 Error Messages

WID-6307 You have only selected one trunk-to-trunk patchcord.

For complete deletion, you must select both patchcords

that are attached to the 10GE_XP/GE_XP cards.

Do you want to continue?

Refer to the warning message text.

WID-6308 You have only selected one trunk-to-OCH patchcord.

For complete deletion, you must select both patchcords

that are attached to the TXP/MXP card.

Do you want to continue?

Refer to the warning message text.

EID-6309 OCHNC circuits, OSC terminations, synchronization sources

and protection groups must be removed before you can remove

this patchcord.

Refer to the error message text.

EID-6310 The Committed Info Rate value must be in range [0-100]. Refer to the error message text.

EID-6311 The MTU value must be in range [64-9700]. Refer to the error message text.

EID-6312 The multicast IP address must be in range

[224.0.0.0 - 239.255.255.255]

Exluding the following IP address subranges

[(224-239).(0/128).0.(0-255)]

Refer to the error message text.

EID-6313 The multicast IP address count must be in range [1-256] Refer to the error message text.

EID-6314 Could not retrieve TTY session for the chosen CRS. Refer to the error message text.

EID-6315 CRS provisioning failed.

{0}

Refer to the error message text.

EID-6316 The chosen node is not a CRS-1. Refer to the error message text.

EID-6317 The value specified for IPv6 Address or IPv6 Default Router is

invalid.

Refer to the error message text.

EID-6318 The value specified for Prefix Length is invalid. Valid range of

values is 0 to 128.

Refer to the error message text.

EID-6319 IPv6 mode can be enabled only if SOCKS and firewall are

enabled on the node.

Refer to the error message text.

EID-6320 IPv6 mode cannot be enabled on a node if RIP is enabled. Refer to the error message text.

EID-6321 IPv6 mode cannot be enabled on a node if 'OSPF on LAN' is

enabled.

Refer to the error message text.

EID-6322 IPv6 Address cannot be specified for {0} when IPv6 mode is

not enabled on the node.

Refer to the error message text.

EID-6323 CTC was unable to delete SnmpV3 Target. Refer to the error message text.

EID-6324 The card mode is invalid in this configuration. Refer to the error message text.

EID-6325 SW version mismatch on node {0}: found {1}, expected {2}. Refer to the error message text.

EID-6326 The CRS node {0} version[{1}] is greater than the supported

version[{2}]. The creation of ochtrail circuits between CRS

nodes will not be disabled, but there could be unexpected

behaviours.

Refer to the error message text.

EID-6327 The end point of patchcord have an incompatible wavelength. Refer to the error message text.

Table 4-1 Error Messages (continued)

Error/Warning

ID Error/Warning Message Description

1 2 ... 357 358 359 360 361 362 363 364 365 366 367 ... 379 380

Comentários a estes Manuais

Sem comentários

Cisco 15310-MA Guia de Resolução de Problemas Página 362

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Cisco 15310-MA